The Urban - Specifications + Options

 

  The Urban
Cab Options
Specifications + Options
Hoistway Information
Brochure Request

The following listing outlines the specification and options available for The Urban elevator system in either Hydraulic or Machine Room-Less (MRL) configurations. Please see the Cab Options page for an illustrated selection of material colors, finishes and optional components.

 

Job Site Electrical Requirements
(provided by others)
230VAC, 60Hz, 30amp single phase power supply with neutral and ground (4 wires) and a separate 115 VAC, 15 amp single phase 60Hz circuit for car lighting
   

Features
Rated load: 950 lbs (431 kg) or 750 lbs. (340 kg)
Speed: 40 fpm (.20ms) nominal
Data plates and capacity tags
Pit depth: 8"
Maximum travel: 40’ (Hydro), 50’ (MRL)
Minimum 14" travel between stops
Number of stops: 4
Approval drawings
   

Hydraulic Model Features:
EECO jack unit
EECO pipe rupture valve
EECO power unit
EECO UV-4R control valve
3 hp motor
Hand pump
Fill/dip stick provision
Minimum overhead: 99” for an 84” cab
   

Machine Room-Less (MRL) Features
Variable frequency speed control
Geared machine with counterweight chain drive
3 hp motor
Minimum overhead: 110” for an 84” cab

Mechanical Equipment
Integral 6 1/4 lb T-rail system
Two #60 roller chains
Sling and platform assembly
   

Car and Appointments
Up to 15 sf cab (per code & design restrictions)
Up to 8’ 0”cab height (per available overhead)
Laminate wall panels (choose from standard options) or unfinished Oak, Birch or Maple veneer wall panels
White or matching ceiling panels
Two recessed MR-16 halogen lights
Surface mounted telephone
Handrail (stainless steel or brushed brass)
Accordion gate (choose from standard options)
Unfinished plywood floor
   

Controls
Microprocessor control
Single automatic push button
Car operating panel (COP) - (brushed stainless steel or brass) with dual LED “CALL” registration and “CAR HERE” light
Hall stations (brushed stainless steel or brass) with dual LED and “CAR HERE” light
Automatic in-use car lighting with on/off switch
Emergency stop switch
Emergency light
Two-way leveling
Hoistway wiring with conduit
Uninterruptible power supply (UPS) for lowering in case of a power failure
Automatic homing

Safety Devices
Car gate safety switch
Car top and pit switch (if required)
115 VAC lockable auxiliary disconnect for car lighting circuit (MRL only)
230 VAC lockable auxiliary disconnect for drive unit circuit (MRL only)
Final limits (2 upper, 1 lower)
Slack chain safety device
Battery backup emergency light and alarm
Electro-mechanical interlocks
   

Optional Features
Designer Thermofoil panel cab
Unfinished recessed or raised panel hardwood cab
Finished hardwood cabs available
Stainless steel or brass handrails in Mirrored and Brushed finishes
Oil rubbed brass fixtures
Recessed phone cabinet
Automatic car gate operator with kinetic energy break-away device
Clear vision panels in accordion gate
Hardwood accordion gates
Key switch controls in COP and/or hall stations
Remote controller